Terrano/Tiger/Mono Key:   = Hard Facing   = Tungsten

Horsch Terrano Leg A = 60cm

Horsch Terrano Leg A = 74cm

Maxipart® Horsch Half-Moon Point (50mm)

1. Low disturbance option, especially good for cutting through heavy clays and reducing surface clods.
2. Tungsten on nose and shin to ensure extended wear life.

Maxipart® Low Disturbance Point Tungsten with Hard Facing (50mm)
AMC30412MXP

1. Deeply recessed bolt holes ensure bolts last the life of the point
2. Hard facing on the sides ensures wear life extended and helps prevent sides undercutting
3. Tungsten tiles added to varying depths to suit depth of cultivations and your working conditions

Maxipart® Mulch Point Tungsten with Hard Facing (80mm)

Maxipart® Mulch Point Tungsten (90mm)
AMC30409MXP

1. Central fin gives extra strength to point
2. Deeply recessed holes mean almost no wear to bolts
3. Recess on rear locks perfectly in place with APC458A/BMXP
4. Tungsten added in a "five-toe" formation for excellent penetration. The leading tile is 5mm thick to help with impact even in the toughest conditions.

Maxipart® Mulch Shin (378mm)
APC458BMXP

1. Much thicker than the APC457A/B, designed to lock in place perfectly with AMC30408MXP, AMC30409MXP and AMC30405.

Maxipart® Mulch Wing

Fixing holes countersunk.

Maxipart® Mulch Wing Tungsten

1. Tungsten plaques butted into the bend of the wing to prevent wear at this often unprotected and vunerable area.

2. Extra thick wings with countersunk bolt holes for bolt head/nut protection.

3. Countersunk holes to protect the bolt head from wearing o

Maxipart® Mulch Wing Tungsten

1. Tungsten plaques butted into the bend of the wing to prevent wear at this often unprotected and vunerable area.

2. Extra thick wings with countersunk bolt holes for bolt head/nut protection.

3. Countersunk holes to protect the bolt head from wearing off.

By using a specialised High Carbon steel, the C60 range allows for the tines to retain optimum flexibility where needed, whilst heat treating the wear tips so that they reach a hardness in excess of 60HRC.

Resulting in an unrivalled high quality performance with maximum wear life.

Maxipart® Disc Cut-away 18” (460mm)

1. Slow press to eliminate disc distortion.
2. Cut rather than pressed bolt holes ensures perfect fitment every time.
3. Outer edge cut onto each disc individually for optimal sharpness.
4. Each scallop individually cut.
5. Optimum hardness ensures extended wear life without cracking.

Maxipart® Disc Cut-away 27” (684mm)

1. Slow press to eliminate disc distortion.
2. Cut rather than pressed bolt holes ensures perfect fitment every time.
3. Outer edge cut onto each disc individually for optimal sharpness.
4. Each scallop individually cut.
5. Optimum hardness ensures extended wear life without cracking.