CO & Sprinter Key:   = Hard Facing   = Tungsten

Maxipart® Direct Drill Point
AMC30125MXP to fit Horsch Co & Sprinters

1. 12mm leading edge for hugely reduced fuel and horsepower requirement.
2. Reduced width means far less disturbance.
3. 130mm of tungsten up leading edge to extend working life.
4. Tungsten placement prevents trash “hooking” around the tine, allowing surface material to flow through the legs.
5. Hard facing on the side and underside helps protect integral seed plates.
6. Splayed seed plates at the rear to ensure free flow of seed, reducing bridging and thus blockages.

Maxipart® Point Tungsten x2
1. High chrome content for extended wear life.

Base Plate 200mm

Maxipart® Base Plate 200mm Tungsten
1. High chrome content for extended wear life.

Double Covering Tine (12mm Thick)